Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 523

Copyright © 2010, Juniper Networks, Inc.
BridgeGroup—Name assigned to the bridge group
Bridge Mode—Bridging capability currently enabled, either concurrent routing and
bridging (CRB) or default bridging
Aging Time—Length of time, in seconds, that a MAC address entry can remain in the
forwarding table
Learning—Whether acquisition of dynamically learned MAC addresses is currently
enabled or disabled
Max Learn—Maximum number of dynamic MAC addresses that the bridge group can
learn
Link Status Snmp Traps—Whether SNMP link status processing is enabled or disabled
for all bridge interfaces in the bridge group
Subscriber Policy—Name of the subscriber policy currently in effect for the bridge
group
Protocol Actions—When CRB is enabled, displays the protocols (IP, MPLS, or PPPoE)
for which explicit routing has been configured
Port Count—Number of ports (interfaces) currently configured for the bridge group;
this value typically matches the Interface Count
Interface Count—Number of bridge group interfaces currently configured for the
bridge group
Address Table—Displays the current static and dynamic entries in the MAC address
table
Address—MAC address of the entry
Action—How the bridge group handles this entry: forward or discard
Interface—Interface type and specifier on which the entry will be forwarded; this
value does not appear for entries that are discarded
Age—Length of time that a dynamic entry has been in the forwarding table; this
value does not appear for static entries
Interfaces—Displays statistics information for each bridge group interface; the entries
for each interface are preceded by the interface type and specifier (for example,
ATM3/3.1)
Port Number—Bridge group port number on which this interface resides
Operational Status—Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Admin Status—State of the physical interface: Up, Down
Snmp Link Status Trap—Whether SNMP link status processing is enabled or
disabled for the specified bridge interface
Chapter 15: Configuring Transparent Bridging
491