Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 396

JunosE 11.3.x Link Layer Configuration Guide
interface pos
load-interval
364
Use to specify PPP as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation ppp
Use the no version to remove the PPP configuration from an interface.
See encapsulation ppp.
Use to configure a POS interface.
To specify a POS interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port[.subinterface ] format.
slot—Number of the chassis slot
port—Port number on the I/O module
subinterface—Number of the subinterface
To specify a POS interface for E120 and E320 routers, use the slot/adapter/port format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
For more information about modules that support POS interfaces, see chapter
Configuring Unchannelized OCx/STMx Interfaces in JunosE Physical Layer Configuration
Guide.
Examples
host1(config-if)#interface pos 0/1
host1(config-if)#interface pos 5/0/0
Use the no version to remove the POS interface.
See interface pos.
Use to set the time interval at which the router calculates bit and packet rate counters.
You can choose a multiple of 30 seconds, in the range 30–300 seconds.
Example
host1(config-if)#load-interval 90
Copyright © 2010, Juniper Networks, Inc.