Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 728

JunosE 11.3.x Link Layer Configuration Guide
696
Profile—Name of the profile that is displayed
IP address—IP address and subnet mask of the interface, or none if the interface is
unnumbered
Unnumbered interface—Specifier for the unnumbered interface, or none if the
interface is numbered
Router—Name of the virtual router (VR) assigned to the profile; interfaces created
by the profile are attached to this VR
Directed Broadcast—Enabled or disabled
ICMP Redirects—Enabled or disabled
Access Route Addition—Enabled or disabled
Network Address Translation—Enabled or disabled; domain location (inside or
outside)
Source-Address Validation—Enabled or disabled
Ignore DF Bit—Enabled or disabled
Filter Option Packets—Router filters out packets with IP options; enabled or disabled
Administrative MTU—MTU size configured on the profile
TCP MSS value—Maximum segment size for TCP SYN packets traveling through the
interface
Inactivity Timer—Inactivity timer setting; enabled or disabled
Route Map Name—Route map applied to the IP interface subscriber; enabled or
disabled
Auto Detect—Router automatically detects packets that do not match any entries
in the demultiplexer table; enabled or disabled
Auto Configure—Dynamic creation of subscriber interfaces on a primary IP interface;
enabled or disabled
IGMP—Enabled or disabled
static-groups—Displays address of any static groups configured for IGMP
Input policy—Name of input policy and whether statistics are enabled or disabled
Output policy—Name of output policy and whether statistics are enabled or disabled
PPP Keepalive—PPP keepalive period, in seconds
PPP Magic Number—Enabled or disabled
PPP Peer DNS Priority—Enabled or disabled
Copyright © 2010, Juniper Networks, Inc.