Ipv6 Characteristics - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

ignore-df-bit Specifies that the don't-fragment bit is ignored
inactivity-timer Configures an inactivity timer value for IP interfaces
inspection Associates an inspection list to the interface for firewalling
mtu Configures the MTU for a network
nat Configures the interface as inside or outside for Network Address Translation
(NAT)
policy Assigns a policy to the ingress or egress of an interface
redirects Enables transmission of ICMP redirect messages
route-cache flow sampled Enables J-Flow statistics on an interface
route-map ip-subscriber Configures the interface for route-map processing
sa-validate Verifies that a packet has been sent from a valid source address
tcp adjust-mss Modifies maximum segment size (MSS) on TCP connections
when path MTU detection is not sufficient
unnumbered Configures IP on this interface without a specific address
virtual-router Specifies a virtual router (VR) to which interfaces created by this
profile attach

IPv6 Characteristics

A profile can contain one or more of the following IPv6 characteristics:
address Configures an IPv6 address on an interface
http Configures the HTTP local server for IPv6
http redirectUrl Configures the URL to which a subscriber's initial Web browser
session is redirected
nd Enables Neighbor Discovery on an interface
nd managed-config-flag Sets the "managed address configuration" flag in IPv6
router advertisements
nd other-config-flag Sets the "other stateful configuration" flag in IPv6 router
advertisements
nd prefix-advertisement Specifies which IPv6 prefixes are included in IPv6
router advertisements
nd ra-interval Configures the interval between IPv6 router advertisements
nd ra-lifetime Configures the router advertisement lifetime
nd reachable-time Configures the amount of time the router can reach an IPv6
node after a reachability confirmation event occurs
nd suppress-ra Disables router advertisement transmissions
mld Configures the multicast listener discovery (MLD) interface
mtu Configures the MTU for a network
policy Attaches (or removes) a policy to (or from) an interface
Chapter 15: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
515