Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 455

Copyright © 2010, Juniper Networks, Inc.
Invalid PAD Tag length—Number of control packets received with an invalid tag
length
Invalid PAD Type—Number of control packets received with an invalid type
Invalid PADI Session—Number of invalid PPPoE Active Discovery Initiation sessions
Invalid PADR Session—Number of invalid PPPoE Active Discovery Request sessions
Invalid PAD packet length—Number of control packets received with an invalid
packet length
Invalid PAD packets—Number of invalid control packets received
Total Invalid PAD packets—Total number of invalid control packets received on the
interface
Insufficient Resources—Number of requests denied because of an inadequate number
of sessions; check the number of active clients
Lockout Configuration (seconds)—Encapsulation type lockout settings for the PPPoE
client associated with the dynamic PPPoE subinterface column; for more information
about these fields, see "Configuring Encapsulation Type Lockout for PPPoE Clients"
on page 544 in "Configuring Dynamic Interfaces" on page 511
Min—Minimum lockout time, in seconds
Max—Maximum lockout time, in seconds
Total clients in active lockouts—Number of PPPoE clients currently undergoing
dynamic encapsulation type lockout
Total clients in lockout grace period—Number of PPPoE clients currently in a
lockout grace period
Example 1
host1#show pppoe interface atm 1/0.1
PPPoE interface ATM 1/0.1 is operStatusUp (dynamic)
PPPoE interface ATM 1/0.1 has max sessions = 4000
PPPoE interface ATM 1/0.1 has acName of 111111111111111
PPPoE interface ATM 1/0.1 will not send ac info in PADS packet
PPPoE interface ATM 1/0.1 is in duplicate-protection
PPPoE interface ATM 1/0.1 will capture remote circuit ID
PPPoE interface ATM 1/0.1 has 1 active connections,
out of 1 configured subinterfaces
Assigned profile (any)
PPPoE Statistics
Counters:
PADI received
PADI transmitted
PADO received
PADO transmitted
PADR received
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
: baseProfile
0
1
1
0
0
423