Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 578

JunosE 11.3.x Link Layer Configuration Guide
546
Configure the underlying physical interface.
1.
For example, the following commands configure a static ATM 1483 subinterface and
corresponding ATM PVC.
host1(config)#interface atm 3/0
host1(config-if)#interface atm 3/0.101
host1(config-subif)#atm pvc 10 10 20 aal5snap
Create a static PPPoE major interface.
2.
host1(config-subif)#encapsulation pppoe
Configure the PPPoE major interface to detect and accept dynamic PPPoE
3.
subinterfaces. Use the lockout-time keyword to configure a nondefault lockout time
range for the PPPoE clients associated with the dynamic PPPoE subinterface column.
For example, the following command configures a lockout time in the range
5–60 seconds for the PPPoE clients associated with the dynamic PPPoE subinterface
column on the PPPoE major interface.
host1(config-subif)#pppoe auto-configure lockout-time 5 60
Assign a profile to the PPPoE major interface.
4.
host1(config-subif)#pppoe profile pppoeLockoutProfile
For information about creating and using profiles, see "Configuring a Dynamic Interface
from a Profile" on page 559.
(Optional) Verify the lockout configuration by using either of the following commands.
5.
To display summary information about the lockout configuration, use the show
pppoe interface command. (The following example shows only the portion of the
command display relevant to the PPPoE lockout configuration.)
host1#show pppoe interface atm 3/0.101
PPPoE interface ATM 3/0.101 is operStatusUp (dynamic)
. . .
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockouts: 0
Total clients in lockout grace period: 0
To display detailed information about the current lockout condition for each PPPoE
client associated with a specific source media access control (MAC) address, use
the show pppoe interface lockout-time command.
This command displays multiple entries for the same MAC address if multiple IWF
sessions contain the same MAC address. In the following example, more than one
entry for the same PPPoE client MAC address, 0090.1a42.527c, is displayed under
the Client Address column head. This method of display occurs because the MAC
address in the Client Address field denotes the MAC address of the DSLAM device
at which multiplexing functions are performed and not the address of the originating
PPPoE client (access loop) for PPPoE sessions that contain the IWF-Session DSL
Forum VSA (26-154).
host1#show pppoe interface atm 12/1/1.1.1 lockout-time
PPPoE interface atm 12/1/1.1
Lockout Configuration (seconds): Min 90, Max 120
Copyright © 2010, Juniper Networks, Inc.