Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 699

interface gigabitEthernet
interface tenGigabitEthernet
profile
profile vlan bulk-config
Copyright © 2010, Juniper Networks, Inc.
Use the no version to remove IP from an interface or a subinterface.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models, and ERX310
router use the slot/port[.subinterface ] format.
To specify a Gigabit Ethernet interface or 10-Gigabit Ethernet interface for E120 and
E320 routers, use the slot/adapter/port[.subinterface ] format.
For more information, see chapter Configuring Ethernet Interfaces in JunosE Physical
Layer Configuration Guide.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Use to create a base profile to configure attributes for a dynamic VLAN subinterface.
Specify a profile name of up to 80 alphanumeric characters.
Example
host1(config)#profile vlanBaseProfile
Use the no version to delete the specified profile.
See profile/
Use to assign the base profile configured for a dynamic VLAN subinterface to the
single-tagged VLAN IDs or double-tagged S-VLAN IDs configured on a static VLAN
major interface.
You must specify both of the following:
Name assigned to the VLAN range on a VLAN subinterface, as specified in "vlan
bulk-config" on page 678
Name assigned to the base profile for a dynamic VLAN subinterface
Example
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
667