Configuring Ieee 802.3Ah Oam Link-Fault Management - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

CHAPTER 7
Configuring IEEE 802.3ah OAM Link-Fault
Management
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure IEEE 802.3ah Operation, Administration, and
Maintenance (OAM) link-fault management on your E Series router, and contains the
following sections:
Ethernet OAM Link-Fault Management Overview on page 224
Ethernet OAM Link-Fault Management Platform Considerations on page 225
Ethernet OAM Link-Fault Management References on page 226
OAM Messages on page 226
OAM Elements Overview on page 227
OAM Client on page 228
OAM Sublayer on page 228
OAM Feature Overview on page 230
OAM Discovery Feature on page 230
OAM Link Monitoring Feature on page 232
OAM Remote Fault Detection Feature on page 234
OAM Remote and Local Loopback Feature on page 235
Interrelationship of OAM Link-Fault Management with Ethernet Subsystems on page 236
Guidelines for Configuring 802.3ah OAM Link-Fault Management on page 237
Configuring 802.3ah OAM Link-Fault Management on page 238
Example: Configuring 802.3ah OAM Link-Fault Management and Enabling Remote
Failure Monitoring on an Interface on page 244
Example: Enabling Remote Loopback Support on the Local Interface on page 245
Monitoring OAM Link-Fault Management Discovery Settings for an Interface on page 245
Monitoring OAM Link-Fault Management Statistics for an Interface on page 248
Monitoring OAM Link-Fault Management Configuration for an Interface on page 250
Monitoring OAM Link-Fault Management Sessions on All Configured
Interfaces on page 253
223