Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 213

pppoe subinterface fastEthernet
pppoe subinterface gigabitEthernet
pppoe subinterface tenGigabitEthernet
svlan ethertype
svlan id
Copyright © 2010, Juniper Networks, Inc.
Use to create a PPPoE subinterface on a Fast Ethernet interface.
Use the no version to remove a PPPoE subinterface on a Fast Ethernet interface.
See pppoe subinterface.
Use to create a PPPoE subinterface on a Gigabit Ethernet interface or on a 10-Gigabit
Ethernet interface.
Use the no version to remove a PPPoE subinterface on a Gigabit Ethernet interface or
on a 10-Gigabit Ethernet interface.
See pppoe subinterface.
Use to assign an Ethertype value for the S-VLAN subinterface.
Choose one of the following Ethertype values:
8100—Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8—Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard 802.1ad
9100—Specifies Ethertype value 0x9100, which is the default
Use an Ethertype value that matches the Ethertype value set on the customer premises
equipment (CPE) to which your router connects.
Example
host1(config-if)#svlan ethertype 8100
Use the no version to restore the default value, 9100.
See svlan ethertype.
Use to assign S-VLAN IDs and VLAN IDs to VLAN subinterfaces.
Use S-VLAN ID and VLAN ID numbers that are in the range 0–4095 and that are unique
within the Ethernet interface.
Use the mac-address keyword to specify a unique MAC address for the VLAN
subinterface. When you do not specify a unique MAC address, the VLAN uses the MAC
address of the Ethernet interface.
Examples
host1(config-if)#svlan id 4 255
host1(config-if)#svlan id 4 255 mac-address 0090.1a01.1234
Issue the svlan id command before any upper bindings are made, such as IP or PPPoE.
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
181