Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 671

atm class-vc
atm pvc
Copyright © 2010, Juniper Networks, Inc.
from the specified VC range. The no version also removes any overriding profile
assignments for ATM PVCs within the deleted VC range or VC subrange.
See atm bulk-config.
Use to assign a previously configured VC class to a base profile for a dynamic ATM 1483
subinterface.
Issuing this command applies the set of attributes in the specified VC class to all
bulk-configured VC ranges that are dynamically created from this base profile.
You must issue the exit command from Profile Configuration mode for the VC class
association to take effect.
Changes to a VC class specified in a base profile apply only to those PVCs that are
dynamically created after the change is made. These changes do not apply to dynamic
PVCs that were created prior to the VC class modification.
Example
host1(config-profile)#atm class-vc gold-subscriber-class
host1(config-profile)#exit
Use the no version to remove the VC class association with the base profile.
See atm class-vc.
Use to apply encapsulation, traffic-shaping, and OAM parameters to the range of ATM
PVCs configured on an ATM AAL5 interface for use by a dynamic ATM 1483 subinterface.
Include this command in the base profile for a dynamic ATM 1483 subinterface.
You must specify one of the following encapsulation types:
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP or
VC multiplexed)
aal5snap—Specifies a logical link control (LLC) encapsulated circuit; the
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram
aal5mux ip—Specifies a VC-based multiplexed circuit used for IP only
You can optionally set the peak, average, and burst sizes. To use VBR-RT or VBR-NRT
as the service type, you must specify each of these options.
The default service type is UBR. To set a different service type, specify one of the
following keywords:
rt—Selects VBR-RT as the service type; you can select rt only if you set the peak,
average, and burst parameters
cbr—Selects CBR as the service type; you must set the CBR rate in Kbps
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
639