Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 190

JunosE 11.3.x Link Layer Configuration Guide
158
Address—MAC address of the processor on this interface
MAU—Type of medium attachment unit (MAU) on the physical port:
10BASE-T (10 Mbps)
100BASE-TX (100 Mbps)
100BASE-FX-MM (100 Mbps) with the distance appearing after the type
100BASE-LX-SM (100 Mbps)
SFP (Empty)—SFPs that are empty
SFP (Non-compliant Juniper Part)—SFPs that are installed in the FE-8 I/O module
and do not have a Juniper Networks part number programmed
MTU—Size of the MTU for this interface
Operational—Size of the largest packet processed
Administrative—Setting for MTU size that you specified
Duplex Mode—Duplex option for this interface
Operational—Duplex option currently used
Administrative—Setting for duplex that you specified
Speed—Line speed for this interface
Operational—Current rate at which packets are processed
Administrative—Setting for line speed
5 minute input rate—Data rates based on traffic received in the last 5 minutes
5 minute output rate—Data rates based on traffic sent in the last 5 minutes
In—Analysis of inbound traffic on this interface
Bytes—Number of bytes received in error-free packets
Unicast—Number of unicast packets received
Multicast—Number of multicast packets received
Broadcast—Number of broadcast packets received
Errors—Total number of errors in all received packets; some packets might contain
more than one error
Discards—Total number of discarded incoming packets
Mac Errors—Number of incoming packets discarded because of MAC sublayer
failures
Alignment—Number of incomplete octets received
Copyright © 2010, Juniper Networks, Inc.