Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 637

Chapter 17: Configuring Dynamic Interfaces
Network Address Translation—Enabled or disabled; domain location (inside or
outside)
Source-Address Validation—Enabled or disabled
Ignore DF Bit—Enabled or disabled
Filter Option Packets—Router filters out packets with IP options; enabled or disabled
Administrative MTU—MTU size configured on the profile
TCP MSS value—Maximum segment size for TCP SYN packets traveling through the
interface
Inactivity Timer—Inactivity timer setting; enabled or disabled
Route Map Name—Route map applied to the IP interface subscriber; enabled or
disabled
Auto Detect—Router automatically detects packets that do not match any entries
in the demultiplexer table; enabled or disabled
Auto Configure—Dynamic creation of subscriber interfaces on a primary IP interface;
enabled or disabled
IGMP—Enabled or disabled
static-groups—Displays address of any static groups configured for IGMP
Input policy—Name of input policy and whether statistics are enabled or disabled
Output policy—Name of output policy and whether statistics are enabled or disabled
PPP Keepalive—PPP keepalive period, in seconds
PPP Magic Number—Enabled or disabled
PPP Magic Number Mismatch—Indicates whether the router is configured to ignore
the LCP peer magic number and retain the PPP connection when the peer has not
negotiated an LCP magic number: ignore (ignore the peer magic number mismatch
and retain the PPP connection), or reject (router terminates the PPP connection if
it detects a peer magic number mismatch)
PPP Peer DNS Priority—Enabled or disabled
PPP Peer WINS Priority—Enabled or disabled
PPP Authentication—Type of authentication configured: PAP, CHAP, or none
PPP Authentication Router—Name of authentication virtual router
PPP Negotiate MRU—MRU configured for the profile
PPP Packet Log—Enabled or disabled
Copyright © 2010, Juniper Networks, Inc. 605