Configuration Example; Configuring Frame Relay Versus Mlfr - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Configuration Example

Configuring Frame Relay Versus MLFR

encapsulation mlframe-relay ietf
interface mlframe-relay
Copyright © 2010, Juniper Networks, Inc.
The following commands configure three T1 lines and aggregate them into a multilink
bundle named boston.
host1(config)#interface serial 2/0:1
host1(config-if)#encapsulation mlframe-relay ietf
host1(config-if)#exit
host1(config)#interface serial 2/0:2
host1(config-if)#encapsulation mlframe-relay ietf
host1(config-if)#exit
host1(config)#interface serial 2/0:3
host1(config-if)#encapsulation mlframe-relay ietf
host1(config-if)#exit
host1(config)#interface mlframe-relay boston
host1(config-if)#member-interface serial 2/0:1
host1(config-if)#frame-relay description bostonBundleDescription
host1(config-if)#frame-relay intf-type dce
host1(config-if)#frame-relay lmi-type cisco
host1(config-if)#member-interface serial 2/0:2
host1(config-if)#member-interface serial 2/0:3
host1(config-if)#exit
host1(config)#interface mlframe-relay boston.1
host1(config-subif)frame-relay description bostonBundleSubOneDescription
host1(config-subif)#frame-relay interface-dlci 16 ietf
host1(config-subif)#ip address 10.10.100.1 255.255.255.0
All the configuration commands that apply to Frame Relay also apply to MLFR. The
following listing describes commands specific to configuring MLFR; for other Frame Relay
commands, see "Configuring Frame Relay" on page 105.
Use to configure MLFR as the encapsulation method on an individual interface.
Use this command only within the context of an individual interface. Issuing this
command creates an MLFR link, also referred to as an MLFR bundle member.
Example
host1(config)#interface serial 2/0:1
host1(config-if)#encapsulation mlframe-relay ietf
Use theno version to disable MLFR on an interface.
See encapsulation mlframe-relay ietf.
Use to create a Frame Relay major interface, also known as the MLFR bundle.
Example
host1(config-if)#interface mlframe-relay group2
Chapter 3: Configuring Multilink Frame Relay
137