Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 172

JunosE 11.3.x Link Layer Configuration Guide
show frame-relay lip
140
LowerLayerDown—Traffic cannot flow because of a problem in an interface at a
lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual administrative
intervention
Number of interface down transitions—Number of interfaces that have changed to
a down state
Time since last status change—Time since the interface last changed its state
In bytes—Number of inbound bytes received on the interface
In frames—Number of inbound frames received on the interface
In errors—Number of inbound errors received on the interface
In discards—Number of inbound packets discarded
In unknown protos—Number of packets received on the interface with unknown
protocols
Out bytes—Number of outbound bytes transmitted on the interface
Out frames—Number of outbound frames transmitted on the interface
Out errors—Number of outbound errors transmitted on the interface
Out discards—Number of outbound packets discarded
Example 1
host1#show frame-relay interface brief
Frame relay interface mlframe-relayTEST, status is up
Example 2
host1#show frame-relay interface mlframe-relay TEST
Frame relay interface mlframe-relayTEST, status is up
Number of interface down transitions is 0
Time since last status change 00:01:47
Number of configured circuits: 2
In bytes: 452
In frames: 19
In errors: 0
In discards: 8
In unknown protos: 0
Example 3
host1#show frame-relay interface mlframe-relay members
Frame relay interface mlframe-relay TEST is up
Frame relay multilink member-interface 4/0:1 is up
Frame relay multilink member-interface 4/1:1 is up
See show frame-relay interface.
Out bytes: 198
Out frames: 11
Out errors: 0
Out discards: 0
Copyright © 2010, Juniper Networks, Inc.