Optional Tasks - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
interface serial
ip address

Optional Tasks

hdlc down-when-looped
506
Use the no version to disable Cisco HDLC on the interface.
See encapsulation hdlc.
Use to configure a serial interface in the appropriate format by selecting a previously
configured physical interface on which you want to configure Cisco HDLC. For example,
to specify a channelized T3 interface, use the format
slot/port:channel/subchannel.subinterface.
slot—Router chassis slot
port—Port on CT3, T3, or E3 I/O module
channel—T1 (DS1) channel
subchannel —Set of DS0 subchannels. For information about T1 subchannels, see
Fractional T1 in JunosE Physical Layer Configuration Guide.
subinterface—User-assigned number that identifies a subinterface
Example
host1(config)#interface serial 3/1:2/1
Use the no version to remove the interface or subinterface.
See interface serial.
Use to assign an IP address and subnet mask to the interface.
Example
host1(config-subif)#ip address 192.32.10.2 255.255.255.0
Use the no version to remove the IP address of the interface.
See ip address.
The following tasks are optional.
Configure the SLARP keepalive interval.
1.
host1(config-if)#hdlc keepalive 10
Enable loopback detection on an interface.
2.
host1(config-if)#hdlc down-when-looped
Disable an interface.
3.
host1(config-if)#hdlc shutdown
Copyright © 2010, Juniper Networks, Inc.