Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 713

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

interface gigabitEthernet
interface tenGigabitEthernet
ip unnumbered
vlan bulk-config
Copyright © 2010, Juniper Networks, Inc.
Use the no version to disable VLAN encapsulation on the interface.
See encapsulation vlan.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
For information about specifying a Gigabit Ethernet or 10-Gigabit Ethernet interface,
see "interface gigabitEthernet" on page 667 and "interface tenGigabitEthernet" on
page 667.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Use to configure an unnumbered IP interface.
This command enables IP processing on an interface without assigning an explicit IP
address to the interface.
You must specify an interface location, which is the identifier of another interface on
which the router has an assigned IP address. This interface cannot be another
unnumbered interface.
Examples
host1(config-if)#ip unnumbered fastEthernet 3/0
host1(config-if)#ip unnumbered loopback 10
Use the no version to disable IP processing on the interface.
See ip unnumbered.
Use to create a bulk-configured VLAN range on a static VLAN major interface for use
by a dynamic VLAN subinterface.
For detailed information about how to use this command, see "vlan bulk-config" on
page 670.
Example
host1(config)#vlan bulk-config test1 svlan-range 200 250 2 2
Use the no version to remove the specified VLAN range from the VLAN major interface,
to remove the specified subranges from the specified VLAN range, or to remove all
subranges from the specified VLAN range. The no version also removes any overriding
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
681

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents