Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 588

JunosE 11.3.x Link Layer Configuration Guide
interface atm
profile
subscriber
556
host1(config-subif)#auto-configure bridgedEthernet lockout-time 3600 21600
Example 3—Disables encapsulation type lockout for the bridged Ethernet encapsulation
type
host1(config-subif)#auto-configure bridgedEthernet lockout-time none
Example 4—Either command reenables encapsulation type lockout for the bridged
Ethernet encapsulation type using the default lockout time range
host1(config-subif)#auto-configure bridgedEthernet
host1(config-subif)#no auto-configure bridgedEthernet lockout-time
Example 5—Permanently locks out the bridged Ethernet encapsulation type until the
auto-configure bridgedEthernet command is issued
host1(config-subif)#no auto-configure bridgedEthernet
Use the no version to terminate detection of the specified encapsulation type or, if the
lockout-time keyword is specified, to restore the lockout time range to its default value,
1–300 seconds.
See auto-configure.
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface atm"
on page 529.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2
Use the no version to remove the interface or subinterface.
See interface atm.
Use to assign a profile.
You must specify the encapsulation type to which the profile applies: bridgedEthernet,
ip, ppp, pppoe , or any.
Specify a profile name with up to 80 alphanumeric characters.
Example
host1(config-subif)#profile bridgedEthernet foo
Use the no version to remove a profile assignment.
See profile.
Copyright © 2010, Juniper Networks, Inc.