Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 223

Copyright © 2010, Juniper Networks, Inc.
Field descriptions when you display the status of a Gigabit Ethernet or 10-Gigabit
Ethernet VLAN or S-VLAN subinterface
Subinterface number—Location of the subinterface that carries the VLAN or S-VLAN
traffic
Administrative status—Operational state that you configured for this interface; up
or down
VLAN ID—Domain number of the VLAN
SVLAN ID—Domain number of the stacked VLAN
Ethertype—Ethertype assignment for the S-VLAN subinterface, 0x8100, 0x88a8, or
0x9100; 0x9100 is the default
In—Analysis of inbound traffic on this interface
Bytes—Number of bytes received on the VLAN or S-VLAN subinterface
Packets—Sum of all unicast, broadcast, and multicast packets received on the
VLAN or S-VLAN subinterface
Multicast—Number of multicast packets received on the VLAN or S-VLAN
subinterface
Broadcast—Number of broadcast packets received on the VLAN or S-VLAN
subinterface
Errors—Total number of errors in all received packets; some packets might contain
more than one error
Discards—Total number of discarded incoming packets
Out—Analysis of outbound traffic on this interface
Bytes—Number of bytes sent on the VLAN or S-VLAN subinterface
Packets—Number of packets sent on the VLAN or S-VLAN subinterface
Multicast—Number of multicast packets sent on the VLAN or S-VLAN subinterface
Broadcast—Number of broadcast packets sent on the VLAN or S-VLAN
subinterface
Errors—Total number of errors in all transmitted packets; some packets might
contain more than one error
Discards—Total number of discarded outgoing packets
Example 1—Displays the status of a Gigabit Ethernet VLAN subinterface
host1:vr2#show interfaces gigabitEthernet 2/0.1
GigabitEthernet2/0.1 is Up, Administrative status is Up
VLAN ID: 10, address 0090.5e00.0001
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
191