Configuring Padm Messages - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide

Configuring PADM Messages

pppoe motm
402
Use to create a PPPoE subinterface on a Fast Ethernet module.
On ERX7xx models, ERX14xx models, and the ERX310 router, use the
slot/port/pppoeSubinterface format.
Example
host1(config)#pppoe subinterface fastEthernet 4/1.1
Use the no version to remove the PPPoE subinterface.
See pppoe subinterface.
You can configure PPPoE to issue and display a PPPoE Active Discovery Message (PADM).
The PADM message is a control message that servers send to clients. The clients may
act on the control message, but are not required to do so. There are two types of PADM
messages:
Message of the minute (MOTM)—Informs clients of interesting system information
URL—Typically spawns an Internet browser with the specified URL as the initial page
You can configure the router to send PADM messages as follows:
Send MOTM messages to all clients connected to the router.
Send MOTM and URL messages to all clients connected to a subinterface.
Configure profiles to send MOTM and URL messages to new clients created when the
profile is dynamically attached to an IP interface.
NOTE: You can use the pppoe motm command at three different points
in the configuration process: Privileged Exec, Interface Configuration, and
Profile Configuration modes. You can use the pppoe url command at two
different points in the configuration process: Interface Configuration and
Profile Configuration modes. Note the differences described in guidelines
below.
Use to cause the PPPoE application to send a PADM message of the minute (MOTM)
message to all PPPoE clients connected to the router. The MOTM string is passed with
no changes.
The message string is not saved in nonvolatile storage (NVS).
Use in Privileged Exec mode.
Example
host1#pppoe motm Router going down at 10:00 p.m.
Copyright © 2010, Juniper Networks, Inc.