Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 622

JunosE 11.3.x Link Layer Configuration Guide
atm pvc
auto-configure
590
To assign a profile to an interface:
Configure a physical interface.
1.
host1(config-if)#interface atm 2/1.10
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation type.
2.
host1(config-subif)#atm pvc 10 100 22 aal5snap
host1(config-subif)#atm pvc 10 100 22 aal5autoconfig
Apply an existing profile.
3.
host1(config-subif)#profile ip holland
Assign subscriber identification.
4.
host1(config-subif)#subscriber ip user ispname domain abc.com
password 3fds9jpt
Enable the dynamic encapsulation type.
5.
host1(config-subif)#auto-configure ip
Use to configure a PVC on an ATM interface. Select one of the following encapsulation
options:
aal5autoconfig—Enables the autodetection of the 1483 encapsulation (LLC/SNAP
or VC multiplexed).
aal5snap—Specifies a LLC encapsulated circuit; the LLC/SNAP header precedes
the protocol datagram.
aal5mux ip—Specifies a VC multiplexed circuit. This option is used for IP only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM subinterface to support a dynamic interface. Specifies one
or more types of dynamic encapsulation that the ATM 1483 subinterface detects and
accepts.
For detailed information about how to use this command, see "auto-configure" on
page 528.
Example 1—Enables autodetection for the bridged Ethernet encapsulation type using
the default lockout time range, 1–300 seconds
host1(config-subif)#auto-configure bridgedEthernet
Example 2—Enables autodetection for the bridged Ethernet encapsulation type using
a nondefault lockout time range of 3600–21600 seconds (1–6 hours)
Copyright © 2010, Juniper Networks, Inc.