Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 155

show frame-relay lmi
Copyright © 2010, Juniper Networks, Inc.
Frame relay interface 3/2:3/1, status is up
Description: chicago03
Time since last status change 01:20:38
In bytes: 19696
In frames: 1231
In errors: 0
See show frame-relay interface.
Use to display configuration and state information and statistics about the LMI for a
multilink Frame Relay, POS, serial, or GRE tunnel interface.
Optionally, you can specify an interface using the interface type and specifier. For more
information, see Interface Types and Specifiers in JunosE Command Reference Guide.
Use the optional delta keyword to specify that baselined statistics are to be shown.
Field descriptions
This command displays both DTE and DCE fields for NNI.
For the DTE:
Enquiries sent—Total number of LMI status enquiries sent by the DTE on this
interface
Full enquiries sent—Total number of LMI full-status enquiries sent by the DTE on
this interface
Enquiry responses received—Total number of LMI full- and regular-status responses
received by the DTE on this interface
Full enquiry responses received—Total number of LMI full-status responses received
by the DTE on this interface
Async updates received—Total number of LMI asynchronous updates received by
the DTE on this interface
Unknown messages received—Total number of unknown LMI messages received
on this interface
Loss of sequencing detected—Total number of times a loss of sequencing in
received LMI messages was detected by the DTE on this interface
No response timeouts—Total number of times a timeout occurred without receiving
a response to an LMI request by the DTE on this interface
Last sequence number sent—Last sequence number sent on this interface
Last sequence number received—Last sequence number received on this interface
For the DCE:
Chapter 2: Configuring Frame Relay
Out bytes: 60744
Out frames: 1231
Out errors: 0
123