Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 121

show atm vc
Copyright © 2010, Juniper Networks, Inc.
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
Assigned VC class
SNMP trap link-status: disabled
Advisory receive speed: 2000
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
Use to display a summary of all configured ATM virtual circuits (VCs) and reserved VC
ranges.
You can specify one or more of the following keywords individually or in combination:
vpi—Displays VCs on a specific VPI
category—Displays VCs that have a specific service category
status—Displays VCs with a certain status
You can also specify the reserved keyword with no other keywords to display only a
summary of all reserved VC ranges on the router. This includes VPI/VCI ranges reserved
for use by dynamic ATM 1483 subinterfaces and by MPLS.
Field descriptions
Interface—Interface number
VPI—Virtual path identifier
VCI—Virtual channel identifier
VCD—Virtual circuit descriptor
: dynamic
: PPPoE
: SNAP
: PPPoE
: none
: Min Max Current Elapsed Next
1 300 0
: none assigned
: none assigned
: pppoeprofile
: none assigned
: dsl-subscriber-class
5119
358672
5107
357510
0
0
3
0
Chapter 1: Configuring ATM
0 1
89