Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 108

JunosE 11.3.x Link Layer Configuration Guide
76
Dropped committed packets, Bytes—Number of committed packets and bytes that
were dropped
Dropped conformed packets 0, Bytes 0—Number of conformed packets and bytes
that were dropped
Dropped exceeded packets 0, Bytes 0—Number of exceeded packets and bytes that
were dropped
Interface—ATM interface identifier
Status—Status of the ATM interface: up, down, lowerLayerDown
Configured VCs—Number of VCs configured on the interface
Example 1—Displays information about a specific interface
host1#show atm interface atm 2/0
ATM Interface 2/0 is down, line protocol is down
AAL5 operational status:
time since last status change: 22:08:21
ATM operational status:
time since last status change: 22:02:11
SONET path operational status: lowerLayerDown
time since last status change: 1 day, 0 hours
SONET operational status:
time since last status change: 1 day, 0 hours
UNI version: 3.0, Maximum VCs: 4096
Current VCs: 1
ILMI VPI/VCI: 17/23, VCD 26, ILMI keepalive: disabled
Max VCI per VPI: 32768
CAC admin state: enabled
Subscription bandwidth: 3000000 kbps
UBR weight: 3000 kbps
Available bandwidth: 2992000 kbps
SNMP trap link-status: enabled
OAM cell receive status: enabled
OAM cell filter : all cells
atm oam loopback-location 0XFFFFFFFF
Interface Alias: ATM interface slot #2 port 0
Assigned VC class
PHY Type: oc3, Framing: sonet, TX clocking: line
Loopback: none, Receive FIFO Overruns: 0
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
InPackets: 0
InBytes: 0
InCells: 0
OutPackets: 0
OutBytes: 0
OutCells: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InByteDiscards: 0
lowerLayerDown
down
down
: dsl-subscriber-class
Copyright © 2010, Juniper Networks, Inc.