Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 315

baseline ppp interface
show ppp interface
Copyright © 2010, Juniper Networks, Inc.
show ppp interface summary
You can set a statistics baseline for PPP interfaces using the baseline ppp commands.
Use the optional delta keyword with PPP show commands to show baselined statistics.
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string that you specify. Refer to the show Commands in JunosE
System Basics Configuration Guide, for details.
NOTE: The E120 and E320 routers output for monitor and show commands
is identical to output from other E Series routers, except that the E120 and
E320 routers output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
Use to establish a baseline for PPP statistics on an interface.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set, then subtracting this baseline whenever baseline-related statistics
are retrieved.
Use the optional delta keyword with PPP show commands to show baselined statistics.
Examples
host1#baseline ppp interface atm 3/3.20
host1#baseline ppp interface atm 3/0/3.20
There is no no version.
See baseline ppp interface.
Use to display selective PPP interface information.
You can filter the command display for characteristics of particular interest, such as
interface type, data type, configured protocol, or interface state.
Field descriptions
inactivity-timeout—Inactivity timeout, in seconds; session is terminated if it is not
active for specified timeout
monitor-ingress-only—Indicates whether the router monitors only ingress traffic for
the configured idle (inactivity) timeout period; true (router monitors only ingress
traffic) or false (router monitors both ingress traffic and egress traffic)
PPP interface—Interface type, interface specifier, and status (up, down, lowerDown,
not present, passive, or tunnel). For more information about specifying the physical
interface on which you want to configure PPP, see Interface Types and Specifiers in
JunosE Command Reference Guide.
Chapter 8: Configuring Point-to-Point Protocol
283