Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 71

atm pvc
interface atm
Copyright © 2010, Juniper Networks, Inc.
In the following procedure, you can repeat Step 2 for each circuit you want to map. You
can associate with an interface a map group name that you have not already established.
When you define the map list, the name is associated with that interface. You can perform
Steps 3 and 4 before Steps 1 and 2 without affecting the results.
To set up a static map:
Create a map list by naming it.
1.
host1(config)#map-list charlie
Associate a protocol and an address with a specific virtual circuit.
2.
host1(config-map-list)#ip 192.168.13.13 atm-vc 1 broadcast
Specify an ATM interface.
3.
host1(config-if)#interface atm 2/0
Associate the map list with the interface.
4.
host1(config-if)#map-group charlie
Use to configure a PVC on an ATM interface.
InARP and refresh rate are optional parameters.
InARP determines whether InARP requests are used and is specified on a per-circuit
basis. If you disable InARP, you must use a static map table entry. Transmission over
the circuit cannot occur unless you use either InARP or static map table entries.
The default refresh rate is 15 minutes.
You can configure InARP only if you specify the aal5snap encapsulation type.
Example
host1(config-if)#atm pvc 6 0 11 aal5snap inarp 10
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM interface or subinterface type.
For information about specifying the ATM interface or subinterface, see "interface atm"
on page 23.
Specify multipoint to identify the subinterface as NBMA.
Examples
host1(config-if)#interface atm 0/1.20
host1(config-if)#interface atm 0/0/4.20
Use the no version to remove the subinterface or the logical interface.
See interface atm.
Chapter 1: Configuring ATM
39