Use By Radius Or L2Tp - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

Table 21: Interface Specifier Format Examples for dsl-forum-1 Keyword
(continued)
Interface Example
Gigabit Ethernet interface on
slot 4, adapter 1, port 1 with
no VLAN or S-VLAN
subinterfaces
Gigabit Ethernet interface on
slot 2, port 0, subinterface 1
with VLAN ID 5
Gigabit Ethernet interface on
slot 4, adapter 1, port 1,
subinterface 3 with VLAN
ID 10
Gigabit Ethernet interface on
slot 2, port 0, subinterface 1
with S-VLAN ID 5 and VLAN
ID 6
Gigabit Ethernet interface on
slot 4, adapter 1, port 1,
subinterface 3 with S-VLAN
ID 10 and VLAN ID 20
Copyright © 2010, Juniper Networks, Inc.
Internal Router Format
gigabitEthernet 4/1/1
gigabitEthernet 2/0.1:5
gigabitEthernet 4/1/1.3:10
gigabitEthernet 2/0.1:5-6
gigabitEthernet 4/1/1.3:10-20

Use by RADIUS or L2TP

Enabling the router to capture and format the PPPoE remote circuit ID sent from the
DSLAM has no effect by itself. To use the PPPoE remote circuit ID value, you must send
it to a RADIUS server, to an L2TP network server (LNS), or to both by doing one or more
of the following:
Issue the radius override calling-station-id remote-circuit-id command to substitute
the remote circuit ID value for the standard Calling-Station-Id [31] RADIUS attribute.
Issue the radius override nas-port-id remote-circuit-id command to substitute the
remote circuit ID value for the standard NAS-Port-Id [87] RADIUS attribute.
Issue the aaa tunnel calling-number-format command to generate L2TP Calling
Number attribute value pair (AVP) 22 in a descriptive format that includes either or
both of the agent-circuit-id (suboption 1) and agent-remote-id (suboption 2) suboptions
of the PPPoE intermediate agent tags.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
How Router Translates
Sets both svlanId and
vlanId to 4096
Uses other values as
supplied
Sets adapter to 0
Ignores subinterface 1
Sets svlanId to 4096
Uses other values as
supplied
Ignores subinterface 3
Sets svlanId to 4096
Uses other values as
supplied
Sets adapter to 0
Ignores subinterface 1
Replaces - (hyphen)
between svlanId and
vlanID with . (period)
Uses other values as
supplied
Ignores subinterface 3
Replaces - (hyphen)
between svlanId and
vlanID with . (period)
Uses other values as
supplied
Format of
dslForum1InterfaceSpecifier
eth 4/1/1:4096.4096
eth 2/0/0:4096.5
eth 4/1/1:4096.10
eth 2/0/0:5.6
eth 4/1/1:10.20
379

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents