Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 573

atm pvc
encapsulation pppoe
encapsulation vlan
interface atm
Copyright © 2010, Juniper Networks, Inc.
NOTE: S-VLAN oversubscription is not currently supported for S-VLANs
configured over bridged Ethernet interfaces.
The E120 and E320 routers can support up to two IOAs per line module. This
maximum number of S-VLANs per line module does not change whether one
or two IOAs are installed. For more information about configuration options
for the ES2-S1 GE-4 IOA, see chapter Configuring Ethernet Interfaces in JunosE
Physical Layer Configuration Guide.
Use to configure a PVC on an ATM interface. Specify one of the following encapsulation
types:
aal5autoconfig—Enables autodetection of the 1483 encapsulation (LLC/SNAP or
VC multiplexed).
aal5snap—Specifies a logical link control (LLC) encapsulated circuit; the
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram.
aal5mux ip—Specifies a VC multiplexed circuit. This option is used for IP only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure PPPoE as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation pppoe
Use the no version to remove PPPoE encapsulation from the interface.
See encapsulation pppoe.
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to remove VLAN encapsulation from the interface.
See encapsulation vlan.
Chapter 17: Configuring Dynamic Interfaces
541