Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 194

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Link Layer Configuration Guide
162
Operational—Current rate at which packets are processed
Administrative—Setting for line speed that you specified
Debounce—Debounce configuration for this interface
State is—Enabled, Disabled
Interval is—Number of seconds that this interface maintains a given state before
the state change is reported to the upper-layer links
Clear arp—State of the removal of the ARP entries on an interface with redundant
ports
Enabled—Clears ARP entries on the interface when the primary link fails
Disabled—Maintains ARP entries on the interface until the specified timeout elapses
Link—Link information for this interface
Operational Link Selected—Port that the I/O module is currently using: primary or
secondary
Administrative link selected—Port that the I/O module is configured to use:
primary—Only primary port is configured to operate
secondary—Only redundant port is configured to operate
automatically—Software controls port redundancy automatically
Link Failover Timeout — Time to wait for a failed link to be active before the router
uses a different active link
Primary link selected x times—Number of times that the I/O has used the primary
port since the module was last rebooted
Secondary link selected x times—Number of times that the I/O has used the
secondary port since the module was last rebooted
Primary/Secondary link signal detected, Primary/Secondary link signal not
detected—Specifies the port (primary or secondary) on which the router detects a
signal
5 minute input rate—Data rates based on the traffic received in the last 5 minutes
5 minute output rate—Data rates based on the traffic sent in the last 5 minutes
In—Analysis of inbound traffic on this interface
Bytes—Number of bytes received in error-free packets
Unicast—Number of unicast packets received
Multicast—Number of multicast packets received
Broadcast—Number of broadcast packets received
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents