Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 604

JunosE 11.3.x Link Layer Configuration Guide
ipv6 mtu
ipv6 nd
ipv6 nd managed-config-flag
ipv6 nd other-config-flag
ipv6 nd prefix-advertisement
ipv6 nd ra-interval
572
Use to set the maximum transmission unit size of IPv6 packets sent on an interface.
Example
host1(config-profile)#ipv6 mtu 1000
Use the no version to restore the default value, 0, which means that the router takes
the value from a lower protocol layer.
See ipv6 mtu.
Use to enable the IPv6 Neighbor Discovery process on an interface.
Example
host1(config-profile)#ipv6 nd
Use the no version to disable the Neighbor Discovery process.
See ipv6 nd.
Use to set the "managed address configuration" flag in IPv6 router advertisements.
Example
host1(config-profile)#ipv6 nd managed-config-flag
Use the no version to clear the flag from IPv6 router advertisements.
See ipv6 nd managed-config-flag.
Use to set the "other stateful configuration" flag in IPv6 router advertisements.
Example
host1(config-profile)#ipv6 nd other-config-flag
Use the no version to clear the flag from IPv6 router advertisements.
See ipv6 nd other-config-flag.
Use to specify which IPv6 prefixes the system includes in IPv6 router advertisements.
Example
host1(config-profile)#ipv6 nd prefix-advertisement 2002:1::/64 60000 45000 onlink
autoconfig
Use the no version to remove any prefixes from the IPv6 routing advertisements.
See ipv6 nd prefix-advertisement.
Copyright © 2010, Juniper Networks, Inc.