Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 702

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Link Layer Configuration Guide
vlan auto-configure agent-circuit-identifier
vlan bulk-config
670
Use to specify the types of dynamic upper-interface encapsulations that are accepted
or detected by a dynamic VLAN subinterface.
Include this command in the base profile for a dynamic VLAN subinterface.
Use the lockout-time keyword to specify the minimum and maximum lockout time
range for the encapsulation type. For more information, see "Encapsulation Type
Lockout" on page 521.
Example
host1(config-profile)#vlan auto-configure ip
Use the no version to terminate detection of the specified encapsulation type.
See vlan auto-configure.
Use to create a VLAN subinterface that is based on the agent-circuit-id information in
the option 82 field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE PADR
and PADI packets.
Include this command in the base profile for a dynamic VLAN subinterface.
Example
host1(config-profile)#vlan auto-configure agent-circuit-identifier
Use the no version to disable creation of VLAN subinterfaces based on
agent-circuit-identifier information.
See vlan auto-configure agent-circuit-identifier.
Use to create a bulk-configured VLAN range on a static VLAN major interface for use
by a dynamic VLAN subinterface.
NOTE: For information about the maximum number of VLAN bulk
configurations supported per chassis, see JunosE Release Notes, Appendix
A, System Maximums.
Each VLAN range consists of one or more nonoverlapping VLAN subranges. A VLAN
subrange is a group of VLAN IDs or S-VLAN IDs that reside within the VLAN range you
specify.
You can configure multiple VLAN ranges on a VLAN subinterface.
When you create a bulk-configured VLAN range, you must specify the following:
A name of up to 80 alphanumeric characters; this is also referred to as the bulk
configuration name
The starting and ending VLAN ID or S-VLAN ID values (inclusive) for each VLAN
subrange
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents