Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 116

JunosE 11.3.x Link Layer Configuration Guide
84
Use to display the current state of all ATM subinterfaces, all ATM subinterfaces
configured on a specified ATM physical interface, or a specific ATM subinterface.
To specify an ATM subinterface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.subinterface format.
slot—Number of the chassis slot
port—Port number on the I/O module
subinterface—Number of the subinterface in the range 1–2147483647
To specify an ATM subinterface for the E120 and E320 routers, use the
slot/adapter/port.subinterface format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
subinterface—Number of the subinterface in the range 1–2147483647
To display brief summary information for all ATM subinterfaces, or for ATM
subinterfaces configured on a specified ATM physical interface, use the summary
keyword.
To display status information only for ATM subinterfaces with a specific operating
status, use the status keyword with one of the following status values. (See the Status
field description for an explanation of these values.)
dormant
dormantLockout
down
lowerLayerDown
notPresent
up
To display the current state of an ATM subinterface created on the PVC with the
specified VPI and VCI values, use the atm slot/port/vpi/vci format (for ERX7xx models,
ERX14xx models, and ERX310 router) or the slot/adapter/port/vpi/vci format (for E120
and E320 routers) to identify the ATM subinterface (Example 5).
Copyright © 2010, Juniper Networks, Inc.