Platform Considerations; Module Requirements; Interface Specifiers - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide

Platform Considerations

Module Requirements

Interface Specifiers

446
"Configuring VLANs over Bridged Ethernet" on page 452 and "Configuring S-VLANs over
Bridged Ethernet" on page 457 for examples that illustrate VLAN and S-VLAN
configurations over bridged Ethernet.
You can configure bridged Ethernet on the following E Series Broadband Services Routers:
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
For information about the modules that support bridged Ethernet on ERX14xx models,
ERX7xx models, and the ERX310 router:
See ERX Module Guide, Table 1, Module Combinations for detailed module specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about the
modules that support bridged Ethernet.
For information about the modules that support bridged Ethernet on the E120 and E320
routers:
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support bridged Ethernet.
The configuration task examples in this chapter use the slot/port[.subinterface ] format
to specify the ATM physical interface on which you want to configure bridged Ethernet.
However, the interface specifier format that you use depends on the router that you are
using.
For ERX7xx models, ERX14xx models, and ERX310 router, use the slot/port[.subinterface
] format. For example, the following command specifies ATM 1483 subinterface 10 on
slot 0, port 1 of an ERX7xx model, ERX14xx model, or ERX310 router.
host1(config)#interface atm 0/1.10
Copyright © 2010, Juniper Networks, Inc.