Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 488

JunosE 11.3.x Link Layer Configuration Guide
mpls
pppoe
pppoe subinterface atm
vlan id
456
Example
host1(config-subif)#ip address 10.1.2.3 255.255.255.255
Use the no version to remove the IP address.
See ip address.
Use to enable, disable, or delete MPLS on an interface. MPLS is disabled by default.
Example
host1(config)#mpls
Use the no version to halt MPLS on the interface and delete the MPLS interface
configuration.
See mpls.
Use to create a PPPoE major interface.
Example
host1(config-subif)#pppoe
Use the no version to remove the PPPoE major interface.
See pppoe.
Use to create a PPPoE subinterface over a VLAN subinterface configured on a bridged
Ethernet interface.
On ERX7xx models, ERX14xx models, and the ERX310 router, use the
slot/port.atmSubinterface.vlanSubinterface.pppoeSubinterface format.
On E120 and E320 routers, use the
slot/adapter/port.atmSubinterface.vlanSubinterface.pppoeSubinterface format.
Examples
host1(config)#pppoe subinterface atm 4/0.1.2.1
host1(config)#pppoe subinterface atm 4/1/0.1.2.1
Use the no version to remove the PPPoE subinterface.
See pppoe subinterface.
Use to specify the VLAN ID.
Use a VLAN ID that is in the range 0–4095 and is unique within the interface.
Issue the vlan id command before any upper bindings are made, such as IP or PPPoE.
Copyright © 2010, Juniper Networks, Inc.