Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 59

atm auto-configuration
atm cac
atm clock internal
Copyright © 2010, Juniper Networks, Inc.
Use the no version to disable the traps.
See atm atm1483 snmp trap link-status.
Use to enable autoconfiguration of ILMI. Entering the atm auto-configuration command
overrides any previous configuration of the atm uni-version command.
Autoconfiguration is enabled by default.
Example
host1(config-if)#atm auto-configuration
Use the no version to disable autoconfiguration and set the ILMI parameters to the
UNI version configured using the atm uni-version command, which has a default value
of UNI 4.0.
See atm auto-configuration.
Use to enable CAC on the interface. You can set a subscription limit, so you can
oversubscribe the port, and the UBR weight, so you can limit the number of UBR
connections.
You cannot configure CAC on an ATM interface on which you have created a
bulk-configured VC range for use by a dynamic ATM 1483 subinterface. Conversely,
you cannot create a bulk-configured VC range on an ATM interface on which you have
configured CAC. For information about creating bulk-configured VC ranges, see "Bulk
Configuration of VC Ranges" on page 627 in "Configuring Dynamic Interfaces Using Bulk
Configuration" on page 619.
Example
host1(config-if)#atm cac 3000000 ubr 3000
Use the no version to disable CAC on the interface.
See atm cac.
Use to cause the ATM interface to generate the transmit clock internally.
You must specify one of the following:
module—Internal clock is from the line module (the default)
chassis—Internal clock is from the configured system clock
Example
host1(config-if)#atm clock internal
Use the no version to cause ATM interfaces to recover the clock from the received
signal.
See atm clock internal.
Chapter 1: Configuring ATM
27