Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 236

JunosE 11.3.x Link Layer Configuration Guide
member-interface
minimum-links
mpls
mtu
pppoe subinterface lag
204
Use to add a Fast Ethernet interface or Gigabit Ethernet interface, also known as a
bundle member, to a LAG bundle.
Example
host1(config-if)#member-interface fastEthernet 4/0
Use the no version to remove the specified Ethernet link from the bundle.
See member-interface.
Use to configure the minimum number of member links in the link aggregation group
(LAG) bundle for the LAG interface to be considered up. The minimum number of
member links that you can configure, depends on the IOA. For example, for ES2–S1
GE-4 IOA, the number of minimum links is in the range 0–4. For ES2–S1 GE-8 IOA, the
number of minimum links is in the range 0–8 and for ES2–S3 GE-20 IOA, the number
of minimum links is in the range 0–8.
Example
host1(config-if)#minimum—links 2
Use the no version to reset the minimum number of member links to the default value,
1.
See minimum-links
Use to enable, disable, or delete MPLS on an interface. MPLS is disabled by default.
Example
host1(config)#mpls
Use the no version to halt MPLS on the interface and delete the MPLS interface
configuration.
See mpls.
Use to specify the MTU for a LAG bundle.
Specify a value in the range 64–9188 bytes. The range for FE-8 I/O modules is 64–9042
bytes.
This command does not work for the Fast Ethernet port on the SRP module.
Example
host1(config-if)#mtu 9000
Use the no version to specify the default, 1518.
See mtu.
Copyright © 2010, Juniper Networks, Inc.