Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 115

show atm subinterface
Copyright © 2010, Juniper Networks, Inc.
round-trip min/max/avg—Minimum, maximum, and average time in milliseconds
that it took to receive responses to ping messages sent
Ping Status—Results of the ping operation
Ping Completed—Number of ping requests in the cell count were sent
Ping in Progress—Ping is in operation
Ping Not Started—Ping operation is not started; you may see this via SNMP
Ping Stopped—Ping operation was manually stopped
Ping Stopped OAM Down—atm oam flush command was issued when ping was
enabled
ATM Interface Down—Ping operation is stopped as a result of interface down
operational status
OAM Flow Type—Segment, End-to-end
Example 1—Displays all entries in the router
host1#show atm ping
Interface VPI VCI CellCount TimeOut SentCellCount RespCount
--------- --- --- --------- -------
ATM 2/1 0 100
ATM 2/1 0 200
ATM 2/2 0 100
ATM 2/2 0 200
% Found 4 Entries in the system
Example 2—Displays entries on an interface
host1#show atm ping 2/1
Interface VPI VCI
--------- --- ---
ATM 2/1 0 100
ATM 2/1 0 200
% Found 2 Entries in this Interface
Example 3—Displays entries on a circuit
host1#show atm ping atm 2/1 0 100
Ping Cell Count
Ping Time Out
No Of Cells Sent
No Of Response Received
Success Rate
round-trip min/max/avg
Ping Status
Oam Flow Type
See show atm ping.
------------- --------- -------
5 5 5
5 5 5
5 5 5
5 5 5
CellCount TimeOut SentCellCount RespCount
--------- ------- ------------- ---------- -------
5 5
5 5
:5
:5secs
:5
:5
:100%
:0/10/2 ms
:Completed
:Segment
Chapter 1: Configuring ATM
Status
5 Ping Completed
5 Ping Completed
5 Ping Completed
5 Ping Completed
Status
5 5 Ping Completed
5 5 Ping Completed
83