Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 177

show frame-relay map
show frame-relay multilinkInterface
Copyright © 2010, Juniper Networks, Inc.
Configured LMI type is ANSI, status is up
Number of interface down transitions is 0
Time since last status change 00:06:20
Enquiries sent: 39
Full enquiries sent: 7
Enquiry responses received: 39
Full enquiry responses received: 7
Async updates received: 0
Unknown messages received: 0
Loss of sequencing detected: 0
No response timeouts: 0
Last sequence number sent: 39
Last sequence number received: 39
See show frame-relay lmi.
Use to display the current Frame Relay and MLFR map entries.
Field descriptions
subinterface—Name and subinterface number of the MLFR bundle in the format
bundle-name.subinterface-number
State of the subinterface—One of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the current
protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an interface at a
lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual administrative
intervention
DLCI number—Decimal value, hexadecimal value, and value as it appears on the
wire of the DLCI
Example
host1#show frame-relay map
Frame relay sub-interface mlframe-relayTEST.1 (up): DLCI 16(0x10,0x4)
Frame relay sub-interface mlframe-relayTEST.2 (up): DLCI 17(0x11,0x14)
See show frame-relay map
Use to display the statistics about all MLFR interfaces or the specified MLFR interfaces.
Field descriptions
Multilink Frame relay interface—Specifier for the Frame Relay interface
State of the MLFR interface—One of the following states:
Chapter 3: Configuring Multilink Frame Relay
145