Assigning Descriptions To Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
ip atm-vc
map-group
map-list

Assigning Descriptions to Interfaces

40
Use to associate a protocol and address with a specific virtual circuit.
Use this command repeatedly for each circuit to be mapped.
This command is available in Map List Configuration mode only.
Example
host1(config-map-list)#ip 192.168.13.13 atm-vc 1 broadcast
Use the no version to remove the association.
See ip atm-vc.
Use to associate the map list with an NBMA interface when configuring static mapping.
You can issue this command before or after the map-list command without changing
anything.
This command is available in Interface Configuration mode only.
See the map-list command.
Example
host1(config-if)#map-group charlie
Use the no version to remove the association.
See map-group.
Use to create a map list when configuring static mapped NBMA interfaces.
Limit the name of the map list to no more than 31 characters.
You can create multiple map lists; however, you can associate only one map list with
each physical interface.
If a map list contains an entry for a VCD that was previously configured to run InARP,
the map-group command fails. If this is the case, either reconfigure the circuit with
InARP disabled, or remove the entry for that circuit from the map list.
Example
host1(config)#map-list charlie
Use the no version to remove the map list.
See map-list.
You can use the description commands to assign a text description or an alias to an
interface, so that other show commands can display that information.
Copyright © 2010, Juniper Networks, Inc.