Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 605

ipv6 nd ra-lifetime
ipv6 nd reachable-time
ipv6 nd suppress-ra
ipv6 policy
Copyright © 2010, Juniper Networks, Inc.
Use to specify the interval, in seconds, between IPv6 router advertisement
retransmissions on an interface.
Example
host1(config-profile)#ipv6 nd ra-interval 500
Use the no version to restore the default interval, 200 seconds.
See ipv6 nd ra-interval.
Use to specify the router lifetime value, in seconds, in IPv6 router advertisements on
an interface. The router lifetime value is the amount of time the router is considered
the default router on this interface.
Example
host1(config-profile)#ipv6 nd ra-lifetime 900
Use the no version to restore the default lifetime, 1800 seconds.
See ipv6 nd ra-lifetime.
Use to specify the amount of time, in milliseconds, that the E Series router can reach
a remote IPv6 node after some reachability confirmation event has occurred.
Example—Sets the reachable-time to 30,000 milliseconds
host1(config-profile)#ipv6 nd reachable-time 30000
Use the no version to restore the default value 0 milliseconds for router advertisements
and 3,600,000 milliseconds (1 hour) for Neighbor Discovery activity of the E Series
router.
See ipv6 nd reachable-time.
Use to suppress IPv6 router advertisement transmissions on a LAN local area network
(Ethernet) interface.
Example
host1(config-profile)#ipv6 nd suppress-ra
Use the no version to reenable the sending of IPv6 router advertisement transmissions
on the LAN (Ethernet) interface
See ipv6 nd suppress-ra.
Use to assign a policy list to the ingress or egress of an interface to which the profile is
attached.
Example
host1(config-profile)#ipv6 policy secondary-input my-policy
Chapter 17: Configuring Dynamic Interfaces
573