Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 459

show pppoe-service-name-table
Copyright © 2010, Juniper Networks, Inc.
LowerLayerDown—Number of interfaces that are not operational because an
underlying interface is down
NotPresent—Number of interfaces that are not operational because hardware is
unavailable
Example
host1:01#show pppoe interface summary
Total PPPoE interfaces: 16
Administrative Status:
Down: 1
Operational Status:
Down: 1
LowerLayerDown: 1
NotPresent: 0
See show pppoe interface.
Use to display the contents of a PPPoE service name table configured on the router.
The command displays the table name, the name of all service name entries in the
table, and the action (terminate or drop) associated with the service name entries.
You must specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
To display the names of PPPoE service name tables that you can specify to complete
the command, issue the show pppoe-service-name-table name ? command.
Field descriptions
Service Name Table—Name of the PPPoE service name table configured with the
pppoe-service-name-table command
Empty service name action—terminate or drop
Service name—Name of the custom service name tag configured with the service
command
action—Action (terminate or drop) associated with the service name tags configured
using the action keyword with the service command.
Unknown service name action—terminate or drop.
Example 1—Displays the names of PPPoE service name tables that you can specify to
complete the command
host1#show pppoe-service-name-table name ?
myDefaultTable
myServiceTable1
myServiceTable2
myServiceTable3
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
Up: 15
Up: 15
myDefaultTable service-name-table
myServiceTable1 service-name-table
myServiceTable2 service-name-table
myServiceTable3 service-name-table
427