Monitoring Bridge Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Monitoring Bridge Interfaces

show bridge interface
Copyright © 2010, Juniper Networks, Inc.
To display only dynamic address entries, use the dynamic keyword.
Field descriptions
Bridge—Name of the bridge group for which the MAC address table is displayed
Address—MAC address of the entry
Action—Specifies how the bridge group handles this entry: forward or discard
Interface—Interface type and specifier on which the entry will be forwarded; this
value does not appear for entries that are discarded
Age—Length of time that a dynamic entry has been in the forwarding table; this value
does not appear for static entries
Example
host1#show bridge westford01 table static
Bridge: westford01 MAC Address Table
Address
--------------
1a11.22b2.333c
1234.abcd.5678
See show bridge table.
You can use the show bridge interface command to display information for a specified
bridge interface or for all interfaces assigned to a bridge group.
Use to display configuration, statistics, and status information for a specified bridge
interface or for all interfaces assigned to a bridge group.
Field descriptions
BridgeGroup—Name of the bridge group to which the interface belongs
Port Number—Bridge group port number on which this interface resides
Operational Status—Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Admin Status—State of the physical interface: Up, Down
Snmp Link Status Trap—Whether SNMP link status processing is enabled or disabled
for the specified bridge interface
Max Learn—Maximum number of dynamic MAC addresses that the bridge group
interface can learn
Subscriber Policy—Name of the subscriber policy currently in effect for the bridge
group interface
Chapter 15: Configuring Transparent Bridging
Action Interface
---------- -------------------
forward ATM3/3.1
discard ---
Age
-----
---
---
497