Platform Considerations; Module Requirements; Interface Specifiers; Configuring Frame Relay - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Figure 4: Interconnection and Relationship of NNIs and Subnetworks

Platform Considerations

Module Requirements

Interface Specifiers

Copyright © 2010, Juniper Networks, Inc.
You can configure Frame Relay interfaces on the following E Series Broadband Services
Routers:
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
NOTE: The E120 and E320 Broadband Services Routers do not support
configuration of Frame Relay interfaces.
For information about the modules that support Frame Relay interfaces on ERX14xx
models, ERX7xx models, and the ERX310 router:
See ERX Module Guide, Table 1, Module Combinations for detailed module specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about the
modules that support Frame Relay.
The interface specifier format that you use depends on the type of physical interface on
which you want to configure Frame Relay.
Chapter 2: Configuring Frame Relay
107