Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 135

show atm vp-tunnel
show mpls cross-connects atm
show nbma arp
Copyright © 2010, Juniper Networks, Inc.
host1#show atm vp-description atm 2/0 1
Interface VPI
ATM 2/0 1
See show atm vp-description.
Use to display a summary of all configured ATM virtual path tunnels.
Field descriptions
Intfc—Interface number
VPI—Virtual path identifier
Type—VP tunnel traffic management type
Kbps—Rate, in Kbps
Description—Text description for the VP, if configured
Example
host1#show atm vp-tunnel 9/1
Intfc VPI Type
ATM 9/1 2 Cbr
See show atm vp-tunnel.
Use to display all ATM cross-connects (passthrough connections between local
subinterfaces).
See section Monitoring ATM Cross-Connects for Layer 2 Services over MPLS in JunosE
BGP and MPLS Configuration Guide for information about using the show mpls
cross-connects atm command.
See show mpls cross-connects atm.
Use to display ARP table entries for ATM NBMA interfaces.
Field descriptions
IP Address—IP address of the entry
VPI/VCI—VPI and VCI of the entry
Interface—Interface specifier of the entry
Example
host1#show nbma arp
NBMA ARP Table Entries
IP Address
1.1.1.2
2.2.2.2
Description
atm20Vpi1Subscribers
Kbps Description
4096 atm91Vpi2Subscribers
VPI/VCI Interface
0/100 4/1
0/101 4/1
Chapter 1: Configuring ATM
103