Configuring Traffic Classes On Multiclass Mlppp Interfaces; Configuring Fragmentation On Multiclass Mlppp Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
Related
Documentation

Configuring Traffic Classes on Multiclass MLPPP Interfaces

Related
Documentation

Configuring Fragmentation on Multiclass MLPPP Interfaces

350
host1(config)#interface gigabitEthernet 3/0/0.10
Specify MLPPP as the encapsulation method on the subinterface.
4.
host1(config-if)#encapsulation mlppp
Enable multiclass MLPPP and specify the number of miltilink classes to create.
5.
host1(config-if)#ppp multilink multiclass multilink-classes 8
Configuring a Dynamic Interface from a Profile in Chapter 17, Configuring Dynamic
Interfaces
ppp multilink multiclass
You can configure mapping of QoS traffic classes to multilink classes. The best-effort
QoS traffic class is mapped to multilink class 0 by default.
To configure mapping of QoS traffic classes to multilink classes:
Specify the QoS traffic classes to be mapped to the multilink classes.
To map QoS traffic classes to multilink classes in a dynamic profile:
host1(config-profile)#ppp multilink multiclass traffic-class best-effort voice
otherData video
To map QoS traffic classes to multilink classes in a static MLPPP interface:
host1(config-if)#ppp multilink multiclass traffic-class best-effort voice otherData
video
NOTE: You must include the best-effort traffic class in the ppp multilink
multiclass traffic-class command, or the command fails.
Chapter 17, Configuring Dynamic Interfaces
ppp multilink multiclass traffic-class
You can configure fragmentation on a multiclass MLPPP interface with the same fragment
size as that of the MLPPP interface.
Before you configure fragmentation on the multiclass MLPPP interface:
Copyright © 2010, Juniper Networks, Inc.