Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 58

JunosE 11.3.x Link Layer Configuration Guide
atm atm1483 mtu
atm atm1483 shutdown
atm atm1483 snmp trap link-status
26
Use to set an advisory receive speed for an ATM 1483 subinterface. This setting has
no effect on data forwarding. You can use it to indicate the speed of the client interface.
When traffic is tunneled with L2TP, the advisory receive speed is sent from the LAC to
the LNS. See LAC Configuration Prerequisites for additional information about the
advisory receive speed.
NOTE: If you specify an advisory receive speed greater than 4294967 kbps,
the speed is not accurately represented in the L2TP AVP, which is in bits
per second (bps).
The range is 0–2147483647 kbps.
Example
host1(config-subif)#atm atm1483 advisory-rx-speed 2000
Use the no version to restore the default behavior—the RX speed is not sent to the
LNS.
See atm atm1483 advisory-rx-speed.
Use to set the MTU size for an ATM 1483 subinterface.
The range is 256–9180.
Example
host1(config-subif)#atm atm1483 mtu 7800
Use the no version to restore the default size of 9180.
See atm atm1483 mtu.
Use to set an ATM 1483 subinterface administrative state to disabled.
When you set the administrative state of the ATM 1483 subinterface to disabled, the
router automatically disables all F5 OAM services configured on the associated VC,
and prevents the VC from receiving or transmitting F5 OAM cells.
Example
host1(config-subif)#atm atm1483 shutdown
Use the no version to enable a disabled subinterface.
See atm atm1483 shutdown.
Use to enable SNMP link status traps on an ATM 1483 layer subinterface.
Example
host1(config-subif)#atm atm1483 snmp trap link-status
Copyright © 2010, Juniper Networks, Inc.