Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 725

show columns
show pppoe interface
Copyright © 2010, Juniper Networks, Inc.
See show atm vc.
Use to display static and dynamic interface counts for each interface column.
Counts for PPP and PPPoE interface columns are updated when the PPP layer comes
up.
Counts for bridged Ethernet and IP over ATM columns are updated when the ATM layer
comes up.
Field descriptions
Type—Interface type
Total—Total number of interfaces on this column
Static—Number of static interfaces on this column
Dynamic—Number of dynamic interfaces on this column
Example
host#show columns
Interface columns:
------------------
Type
-------------------- ---------- ---------- ----------
Bridged Ethernet
IP over ATM
PPP
PPPoE
See show columns.
Use to display summary information about the encapsulation type lockout parameters
configured for PPPoE clients on a dynamic PPPoE subinterface column.
The following field descriptions and example include only the portion of the show
pppoe interface command display relevant to lockout configuration for PPPoE clients.
For more information about using this command, see "show pppoe interface" on page 421
in "Configuring Point-to-Point Protocol over Ethernet" on page 371.
Field descriptions
Lockout Configuration (seconds)—Encapsulation type lockout settings for the PPPoE
client associated with the dynamic PPPoE subinterface column
Min—Minimum lockout time, in seconds
Max—Maximum lockout time, in seconds
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Total Static Dynamic
4 2
4 2
22 12
10 5
2
2
10
5
693