Subrange - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
auto-configure vlan
encapsulation vlan
interface fastEthernet
666
Removing Overriding Profile Assignments from a VLAN Range or VLAN Subrange
When you issue the no vlan bulk-config command to remove an entire VLAN range (and
all VLAN subranges within that VLAN range), the router also removes any overriding
profile assignments configured for VLAN IDs within those VLAN subranges. For example,
the following command removes the bulk-configured VLAN range named myBulkConfig
and any overriding profile assignments for VLAN IDs within the VLAN subranges belonging
to myBulkConfig.
host1(config-if)#no vlan bulk-config myBulkConfig
When you issue the no vlan bulk-config command to remove a particular VLAN subrange
in a bulk-configured VLAN range, the router also removes any overriding profile
assignments for VLAN IDs within that VLAN subrange. However, overriding profile
assignments for VLAN IDs within other VLAN subranges in the VLAN range remain intact.
For example, the following command removes one VLAN subrange (S-VLAN IDs 50–150
and VLAN IDs 150–250) and only those overriding profile assignments associated with
this subrange.
host1(config-if)#no vlan bulk-config myBulkConfig svlan-range 50 150 150 250
Use to configure the static VLAN major interface to support autodetection of an VLAN
dynamic interface type.
You must issue this command to enable creation of a dynamic VLAN subinterface.
By default, all valid VLAN IDs and S-VLAN IDs are accepted.
Example
host1(config-if)#auto-configure vlan
Use the no version to terminate autodetection of the VLAN dynamic interface type.
See auto-configure vlan.
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN on an interface.
See encapsulation vlan.
Use to select a Fast Ethernet interface.
For information about specifying a Fast Ethernet interface, see "interface fastEthernet"
on page 666.
Example
host1(config)#interface fastEthernet 4/1
Copyright © 2010, Juniper Networks, Inc.