Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 146

JunosE 11.3.x Link Layer Configuration Guide
interface serial
ip address
114
slot—Router chassis slot
port—Line module port
Example
host1(config)#interface pos 0/1
Use the no version to remove the POS interface.
See interface pos.
Use to configure a serial interface in the appropriate format by selecting a previously
configured physical interface on which you want to configure Frame Relay. For example,
for a channelized T3 interface use slot/port:channel/subchannel.
Use to configure a Frame Relay subinterface in the appropriate format by selecting a
previously configured physical interface. For example, for a T3-Frame interface use
slot/port.subinterface ; for a channelized T1/channelized E1 interface use
slot/port.channel-group.subinterface.
NOTE: Before you configure Frame Relay, see the appropriate chapter in
this guide for details on configuring physical interfaces.
slot—Router chassis slot
port—CT3, T3, or E3 module I/O port
channel—T1 (DS1) channel
subchannel—Set of DS0 timeslots. See section Fractional T1 in JunosE Physical Layer
Configuration Guide
subinterface—User-assigned nonnegative number that identifies a Frame Relay
subinterface
Example
host1(config-if)#interface serial 3/1:2/1.1
Use the no version to remove the subinterface or the serial interface.
See interface serial.
Use to assign an IP address and subnet mask to a subinterface.
Example
host1(config-subif)#ip address 192.32.10.2 255.255.255.0
Use the no version to remove an IP address or to disable IP processing.
See ip address.
Copyright © 2010, Juniper Networks, Inc.