Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 130

JunosE 11.3.x Link Layer Configuration Guide
show atm vp
98
OAM alarm clear time out—Number of seconds that the router waits before reporting
that a PVC is up after the PVC has stopped receiving alarm cells
OAM continuity check—Status of F5 OAM continuity check verification on the PVC:
enabled or disabled
Inverse ARP—Status of Inverse ARP (InARP) on the PVC: enabled or disabled
Example 1
host1#show atm vc-class
premium-subscriber-class
dsl-subscriber-class
found 2 VC class entrie(s) in the system
Example 2
host1#show atm vc-class premium-subscriber-class
Encapsulation Type
Service Category
Peak Cell Rate
OAM VC Integrity
OAM VC Integrity loop-back timer
OAM alarm down count
Example 3
host1#show atm vc-class premium-subscriber-class include-defaults
Encapsulation Type
Service Category
Peak Cell Rate
OAM VC Integrity
OAM VC Integrity loop-back timer
OAM VC Integrity Up Retry Count
OAM VC Integrity Down Retry Count
OAM VC Integrity Retry Frequency
OAM alarm down count
OAM alarm clear time out
OAM continuity check
Inverse ARP
See show atm vc-class.
Use to display detailed statistics for a specific ATM VP configured on the router.
Field descriptions
ServiceCategory—Service type on the VP tunnel, if configured: UBR, UBR-PCR,
VBR-NRT, VBR-RT, or CBR
Peak Cell Rate—Peak cell rate in kilobits per second, if a VP tunnel is configured
Maximum VCI per VPI—Maximum number of virtual circuits on each virtual path
Current VCs—Number of VCs currently configured on the router
InPackets—Number of packets received
:AUTO
:CBR
:200 kbps
:enabled
:60 seconds
:5
:AUTO
:CBR
:200 kbps
:enabled
:60 seconds
:3
:5
:1
:5
:3 seconds
:disabled
:disabled
Copyright © 2010, Juniper Networks, Inc.