Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 323

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
link down—Link is down and the protocol is not operationally up. This applies to
IPCP, IPv6CP, OSINLCP, and MPLS.
lower layer down—Lower protocol layer is down. This applies to an interface only.
max configure exceeded—Maximum number of configure requests was exceeded
while negotiations were in progress. This means that there was no response from
the peer, or the peer refused to negotiate. This applies to an interface, IPCP, IPv6CP,
OSINLCP, and MPLS.
peer requested termination—Remote peer requested termination of the connection,
which means that a terminate request was received while the session was in an
open state. This applies to an interface, IPCP, IPv6CP, OSINLCP, and MPLS.
Example 1—Provides detailed output for a particular IP interface
host1#show ppp interface gig 2/1/7.1.1 full
PPP interface GigabitEthernet 2/1/7.1.1 is upp
Interface administrative status is open
Configured network protocol is IPCP
IPCP protocol configuration
configured
administrative-status
ip-address
dns-precedence
wins-precedence
ipcp-netmask-option
ipcp-lockout
max-negotiations
ipcp prompt-option dns
IPCP protocol status
operational-status
IPCP negotiated options
ip-address
ip-address-mask
primary-dns-address
secondary-dns-address
primary-wins-address
secondary-wins-address
IPV6CP Protocol Configuration
configured
administrative-status
ipv6-interfaceId
max-negotiations
IPV6CP protocol status
operational-status
OSINLCP protocol configuration
configured
administrative-status
OSINLCP protocol status
operational-status
Interface statistics
packets
octets
errors
discards
policed
LCP protocol configuration
max-receive-unit
Chapter 8: Configuring Point-to-Point Protocol
true
open
6.6.6.6
local
local
disabled
disabled
30
enabled
up
local
11.1.1.1
none
none
none
none
none
false
open
0.0.0.0
30
not present
false
open
not present
in
0
14515
0
0
0
use lower layer
peer
11.1.1.2
none
none
none
none
none
out
0
11296
0
0
0
291

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents